NASM Forum > Using NASM

16-32 bit...

(1/1)

nobody:
Hi everybody!I want to refer to an offset as a 16 bit while i am in a 32bit segment. When i am in NASM i use [BITS16] instruction..Is there sg similar for MASM? I am trying to set up the IDT and i get an error when trying to load the entry point.Thanx!!

Frank Kotler:
Dunno... You might be better off asking this question in a Masm forum...

This sounds like it might be code for something other than a MS operating system. Read the EULA carefully!

Best,
Frank

Navigation

[0] Message Index